Coat - Epoxy Waterbased Coating
Resin Coat is a 2 component water based epoxy coating to be used to protect a
variety of industrial substrates. This coating offers, in an easy way, a durable
and long term solution to dusty substrates and it is even chemically resistant.
This coating is almost odourless and very environmentally friendly.
- Order - Ask Info
Resin Coat can be applied on a variety of substrates like concrete, cement, wood,
The specific application for Resin Coat is the
renovation of concrete where a much more mechanically and chemically resistant
surface is achieved.
Coat is also an aesthetic smooth finish which is makes the surface dust free and
resistant to oil.
|Easy : Resin Coat is,
after mixing the components, applied as a normal paint with a brush or roller.
Chemically resistant : After
hardening, Resin Coat forms a closed film which is resistant to most chemical
Hygienic: It is a high quality
odourless coating giving a clean surface that is easy to maintain..
Aesthetic: Resin Coat Water based
results in a beautiful surface finish.
|Application is done at a
substrate temperature of minimum 12°C and a humidity content in the substrate of
The coating is applied by means of a
normal roller on a clean substrate. Working with a lacquer roller will enhance the
orange peal effect.
Normally, the application of 1 coat is sufficient.
2 Coats give a nicer finish though.
The coating dries in 12 hours. One should wait 48
hours to put loads on the coating.
coating is composed of the following elements:
Component A : modified epoxy resin
Component B : modified aliphatic diamine
It should be mixed as A/B = 1/1
Delivered and applied
In packs of 4 Kg.
Depending on the state of the substrate one used
normally 6-9 m2/Kg of this coating.
All products can
be stored for at least 1 year if kept in a dry environment at a constant temperature above
of substrate. Satiné effect.
80 - 150 micron depending on the kind of substrate
after 12 hours at 20°C.
Mechanical load after 36 hours at 20°C.
Chemical resistance after 7 days at 20 °C.
mixing ca. 45 minutes.
good adhesion on a variety of substrates.
|| See list of Chemical Resistance for ResTech Prod.
ResPrim 1T: Epoxy-coal tar coating.
ResCoat CB: 2 component epoxy coating.
Super Coat: 2 component polyurethane coating.
Liquid Plastic: 1 component coating.
All information herein has been described following our best ability and
knowledge at this moment. All herein mentioned products should be used following the local
laws and regulations concerning the use of this kind of products and their application.
For all further information you can always contact our technical services.